Carrera RSR wrote:
Fitted new hatch seal and pins last weekend. Fitted these
http://only944.com/partscatalog/only/hatchpinseats.html today. No more leaks, squeaks or rattles. Hatch also pops up on command of the the key. Happy days.
Gave it a good clean with new snow foam lance including wheel arches and sill areas. Then made some mods to the front. Whilst I like the reg plate off the bumper I am not convinced by the placement on the bonnet. Alternative is the badge panel.

The reason for this is I'm considering fitting the air duct from a 951 from bumper to intercooler. This would mean putting a slot in the front bumper where the front plate would be. So before I cut the slot I want to look at alternative plate placement, ideally off the red areas.
Carrera RSR wrote:
Fitted new hatch seal and pins last weekend. Fitted these
http://only944.com/partscatalog/only/hatchpinseats.html today. No more leaks, squeaks or rattles. Hatch also pops up on command of the the key. Happy days.
I am looking into new hatch pins but this innovation that you have posted looks quite interesting! Did you have to sand down your new hatch pins in order to fit the kit or did the lot simply work?
It has to be said that I believe your '24 has to be one of the most stunning Frontrunners I have seen, with you seeming to have got the philosophy and looks of the car just right. I do agree on the plate looking a little lost on top of the bonnet, the badge panel should be a better bet

.