Porsche Enthusiasts Club Forum

Ok I just recived the chin spoiler from pro 9 ( same sold by Porsche shop ) I have offered it up and it seems a good fit so far, just required one side of the bumper pushed in 2 meet it. Wether this is the bumper out or the chin spoiler I'm yet 2 find out, are offer up the ome undertray/batwing and see which is 2 blame. The spoiler isn't ready 4 spary and fitment, White primer has drips and needs sanding down 2 a tidy finish. This will be my job Sunday. As I'm working tmw. This will be my job Sunday so are post some pics up then.

ok spoiler been on the car 4 over a week now and has covered a few miles, all seem ok, only cught it twice on the floor, its fine over speed bumps.

heres some pics about fit and a little mod i done 2 get it looking good.

i took the bumper off and mounted the chin spoiler with self taped screws, this was pretty easy and the fit around the front of the bumper was pretty good. only place i had troble was at the sides, was just short of the wheel arch, so i cut the bumper 2 fit the chin spoiler and re shaped the end off the spoiler 2 macth the rest off the cars wheel archs. then cut the the under neathe of the chin spoiler 2 meet the new shaped ends.

over all im quite happy with the item, finsh would require a lot of sanding 2 become ready 4 paint, however been so low its dosent notice

Looks good! My car will be getting one of these in a couple of weeks, from SAR Classics though, instead of Pro 9.

Yeah they do look nice, there a lot flater and not as low looking plus don't require painting, I had a little bump with mine today, ;( . There was a low slab in a parking space I didn't see and the front cught it. A loud crunch noise was the only result, lucky no damage, but the shock did cas some paint peal on the bumper.