Porsche Enthusiasts Club Forum

Hi all,

I recently picked up a 944 S2, thats a bit cosmetically tatty, but the mechanics are sound.

There is one thing thats not working as it should.

The warning lights are not being displayed. I have no master light, water temp overheat, handbrake etc. I DO have the ABS warning and seatbelt warning.

Im hoping its just bulbs gone, but if not, is there a fuse or relay that controls this system? im new to the 944, but im assuming the sensors feed to the ECU which then lights up the dash/

Well done on your purchase! Post us some pics. As to the warning lights. Mine had virtualy no bulbs in it as the previous owner had taken them out rather than fix it! Possible that a fuse has gone if you don't have any. Takes some time to get the clocks out but you can do it with the wheel in situ' if your careful. 3 multi pin plugs to remove & you have to be good at brail to get them off. One at each side & one on the right hand side in the back. They have secure clips that have to be released. Just takes time & care. May just be that one of the cables isn't clipped on right. There a pig to get at! If your anywhere near me can point you in the right direction. Have to take mine off again as a label has apeared out of the milometer so you cant read the mileage.

Thanks JJ, ill put some pics up when i get the bodywork up to standard. Hopefully have a chance to take the dash out at the weekend.