Page 1 of 1
Correct position for the bonnet badge on a pre 73 longhood
Posted: Wed Mar 04, 2015 6:57 am
by Klassiker 911
I'm in the final stages of a backdate project and getting to the finishing touches, badges etc. can anyone tell me the exact position the bonnet badge should be fitted? Dimensions from the front edge of the bonnet would be good
Re: Correct position for the bonnet badge on a pre 73 longho
Posted: Thu Mar 05, 2015 9:29 pm
by Klassiker 911
Please, can someone give me the accurate dimensions from the front edge of the bonnet to the bottom of the badge or mounting holes
Re: Correct position for the bonnet badge on a pre 73 longho
Posted: Sat Mar 07, 2015 12:08 pm
by savagewomble
I'm just on way back to uk. I will measure mine tomorrow. Would you like the dimensions to the mounting holes or the badge itself?
Cheers
Dan
Re: Correct position for the bonnet badge on a pre 73 longho
Posted: Sun Mar 08, 2015 1:54 pm
by savagewomble
Hi
I've just measured my bonnet badge and it is 165mm from the front edge to the bottom point of the badge.
hope this helps
Dan
Re: Correct position for the bonnet badge on a pre 73 longho
Posted: Sun Mar 08, 2015 10:11 pm
by Klassiker 911
Dan,
cheers, that's the measurement I was after
Matt