I hope it is. I don't have the heat shield on nor do I have the pump/filter housing nor the exhaust or the drive shafts.Waylander wrote:Think the 44 will be easier...
The previous one ^ was just a fiddle.
Moderator: Moderators
I hope it is. I don't have the heat shield on nor do I have the pump/filter housing nor the exhaust or the drive shafts.Waylander wrote:Think the 44 will be easier...
Waylander wrote:Helps if you get the number right.
Crank Case wrote:Been wrestling with the steering rack and steering column today.. Was hoping to fit the front anti-roll bar but didn't get that far. (I'm a poet and I don't know it).
This is what it looked like before...
...and this is what it looked like just before I put it on:
Tomorrow: anti-roll bar and some bits and after that... a wait.
I replaced that to my S2 cab a few years ago (it was cracked an ratling like ball bearings in a tumble dryer)Waylander wrote:
there is a heat shield at the bottom as well,
for engine 4441 944 107 053 04 @ £126.65
That's the one. I have the others. May as well wait for Porsche to 're-open' and buy it new.Waylander wrote:...there is also a shield that locates on the cross member for the bottom joint of the column
952 341 108 02 £17.76