Porsche Enthusiasts Club Forum

Hi could someone tell me please, the correct routing of the wiring for the oil pressure sender on the engine (where it runs around under inlet manifold across front of engine and down to sender)
Thanks Neal

Hi,
Or could someone be so kind as to photograph the the front of their engine please ?
Regards Neal

Hi, here is a photo of a 16V engine wiring, as you can see the cabling runs under the inlet manifold and across the front, then behind the plastic belt cover and down to the oil pressure switch and oil level switch (if fitted). It also goes to the hall sensor on the cam sprocket. I hope it helps!

Hi Rhett,
thanks very much. So to be a pain but any chance of a photo further down on the left please ? Trying to see if wiring then runs down front of water pump before heading back to sender.
Many Thanks again.
Neal

Yes it does