[quote="Clive993"
As to getting behind the glass, i dont know ...it may be a sealed unit?[/quote]
think it is
| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Removing/cleaning rev counter glass - How? https://forums.tipec.net/viewtopic.php?f=8&t=7360 |
Page 1 of 1 |
| Author: | Hilux [ Sun Dec 06, 2009 11:16 am ] |
| Post subject: | Removing/cleaning rev counter glass - How? |
A friend has a 997 TT 4wd The rev counter has had condensation behind it which has left it water marked. Is there a guide on how to remove the cluster/glass etc so it can be cleaned other than sending a trained hamster with a microfibre cloth up into the dash board? He`s had some serious classic Porkers for years but never joined the club (hes not a club type) so I hope you dont mind me asking on his behalf. |
|
| Author: | Hilux [ Mon Dec 07, 2009 10:34 am ] |
| Post subject: | Re: Removing/cleaning rev counter glass - How? |
OOOps Its a 993 - 1997 vintage |
|
| Author: | Clive993 [ Mon Dec 07, 2009 2:44 pm ] |
| Post subject: | Re: Removing/cleaning rev counter glass - How? |
the answer is either easy or a pig dependent on how lucky you are. The rev counter will just pull out with some leverage. Sometimes it is easier to remove the clock or another gauge to the right of the rev and push from behind. Here is the BUT - i some cases the counter will come out past the steering wheel and in others not. its a matter of millimetres and there is now reason why some do and some dont. If it does not come out then its a steering wheel off job and with air bags be VERY careful As to getting behind the glass, i dont know ...it may be a sealed unit? |
|
| Author: | sam [ Mon Dec 07, 2009 4:37 pm ] |
| Post subject: | Re: Removing/cleaning rev counter glass - How? |
[quote="Clive993" As to getting behind the glass, i dont know ...it may be a sealed unit?[/quote] think it is
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|