| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Rollcage https://forums.tipec.net/viewtopic.php?f=7&t=12840 |
Page 1 of 1 |
| Author: | 964russ [ Tue Apr 24, 2012 8:50 pm ] |
| Post subject: | Rollcage |
As you may have seen my car has a rear cage fitted, ive just got a front section of fleabay. Question is do i fit it? Ive placed it in place an it makes an allready small car even smaller, i like the look, the road racer look is awesome! But ill have to ditch the door pockets and sun visors, and all thou its safer in 1 respect in the other that big steel tube runs v close to your head, probably fine with a lid on but on the road 
|
|
| Author: | lindsayhbrown [ Tue Apr 24, 2012 8:52 pm ] |
| Post subject: | Re: Rollcage |
You could always pad it with foam pipe insulation |
|
| Author: | sirion [ Wed Apr 25, 2012 8:30 am ] |
| Post subject: | Re: Rollcage |
964russ wrote: that big steel tube runs v close to your head, probably fine with a lid on but on the road I thought long and hard about fitting a full cage to the 68, but in the end decided against it for this very reason. I think on the road with no lid on it just has the potential to cause a bigger problem than it solves. Different matter on track with lid and full harness of course.  Is it weld in or a bolt in? If bolt in you could just fit for track days. |
|
| Author: | 964russ [ Thu Apr 26, 2012 6:27 pm ] |
| Post subject: | Re: Rollcage |
Bolt in mate. But dont know if i can be arsed with fitting and then removing it. Dunno wot to do 
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|