Porsche Enthusiasts Club Forum

Hi all,

I have a 2.7 944 race engine, surplus to requirements which has been stripped down for parts.

The engine was rebuilt in around 2007 by the previous owner and had been raced on and off up until 2010 and then raced again by me from 2012 until early this year when I swapped to an S2 lump.

I have listed some of the parts on eBay here, including:

Cam tower/box complete with cam, cam gear
Inlet manifold
Throttle body
Block (wear to one cylinder) including matched balance shaft covers and crank girdle
Flywheel
Oil cooler housing and matrix
Oil pressure relief valve - latest revision (brand new in packaging)
2.7 DME - chipped with race map
2.7 DME - stock
S2/968/944 turbo - twin radiator fan
S2 front bumper support bar
2 x S2 front bumper support bar brackets

still more to add including:

Bell housing
Clutch cover
Oil pressure relief valve
2.7 pistons and rods complete
S2 throttle body and MAF
Fibreglass 2 piece dash board
Crossmember/subframe

Edited post with new parts available