neilbennet944 wrote:
I would like to re-introduce Tyre pressure monitoring, so do you or anyone know how to do this. Obviously I need to make sure I remove and back-out correctly and have the correct components in place.
Well, first question is do you already have the correct (original) wheels with the sensors, I think they were only ever fitted to the "manhole cover" and Design 90 wheels - the pressure sensors are screwed into the body of the wheel (where the rubber blocks are), so they can't easily be retro-fitted to other wheels; secondly the sensors are very expensive, so unless you've already got them you're unlikely to want to buy a complete new set.
If you do have the wheels with sensors then remove the bridging wires from the plug in the footwell, reattach it to the ECU and see what warning messages if any come up on the dash - that should give you some clue as to the reason why it has been disconnected and what might need fixing.
neilbennet944 wrote:
The Ventilation Grill is the Shutters and the arm to them is missing and there is some gaffer tape wrapped around to hold them open.
Might be fun to get these to work again, if anyone knows how to
Similar to the tyre pressure sensors, it's probably been disconnected for a reason, but unless you have all the bits there to start with you can't easily tell what that was. There might be a diagnostic procedure in the workshop manual but it's not really part of the car about which I know much.