stratfordshark wrote:
Good tip is to loop tie-wrap under relay before installing, then you can just pull the loop to remove relay in future.
Very good tip................ (even if he does use a Mac and Iphone)
| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Relay removal tool ? https://forums.tipec.net/viewtopic.php?f=27&t=11754 |
Page 1 of 1 |
| Author: | kenthepipe [ Fri Oct 07, 2011 12:02 pm ] |
| Post subject: | Relay removal tool ? |
Has anyone any links where I can buy a decent relay removal tool ? Currently I use a bent piece of stainless steel old ruler, but would like to get something that grips both sides at once, and avoid a dismantled relay, Uk only ? |
|
| Author: | stratfordshark [ Fri Oct 07, 2011 1:21 pm ] |
| Post subject: | Re: Relay removal tool ? |
I always carry these in car. http://www.teng.co.uk/ak421-sealey-rela ... 587_pd.asp Good on single size relays, less use with double relays so they were no help with Mark's last saturday, mind you only the base was left in the socket so not much to grip! You still have to be careful to grip base to avoid pulling can off but used properly they are fine. Good tip is to loop tie-wrap under relay before installing, then you can just pull the loop to remove relay in future. |
|
| Author: | Andrew [ Fri Oct 07, 2011 1:51 pm ] |
| Post subject: | Re: Relay removal tool ? |
stratfordshark wrote: Good tip is to loop tie-wrap under relay before installing, then you can just pull the loop to remove relay in future. Very good tip................ (even if he does use a Mac and Iphone)
|
|
| Author: | kenthepipe [ Mon Oct 10, 2011 9:50 am ] |
| Post subject: | Re: Relay removal tool ? |
...., thank,s for the link Adrian 
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|