Hi All
![Smile :)](./images/smilies/icon_smile.gif)
YAYYYYYYYY,,,finally have brake lights....
![Smile :)](./images/smilies/icon_smile.gif)
Long story on cure but basically there were two problems... lol
One was the broken brown wire in the top of the bulb control module...soldered that and that bit was fine, but still no brake lights at rear....
So rang Paul A and he talked me through testing every connection and fuse and connector on fuse board... lol
So we finally got to...it SHOULD be working assuming a good 12 volt feed at the pedal switch.....
I said ... its got a red light on my Snap-On probe....
Paul said..... hmmm... that doesnt mean its got a GOOD 12 volt feed.....
He said... try running a separate 12 volt wire from my Nitrous fuse board....
So did that, attached a new terminal and voila.... all working....
I still cannot quite figure out why the old wire (which comes from fuse 4) would light my probe but not have enough ooommmpph to run the brake lights...lol
But Paul was absolutely spot on and spent around 40 minutes on the phone with me running through all the testing.....
Amazing service from him as usual
![Smile :)](./images/smilies/icon_smile.gif)
I am so relieved they are working as its REALLY annoying even though its a small thing lol...
Thanks to Paul and Adrian yet again.....
![Smile :)](./images/smilies/icon_smile.gif)
All the best Brett
![Smile :)](./images/smilies/icon_smile.gif)