| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Handbrake microswitch https://forums.tipec.net/viewtopic.php?f=25&t=9521 |
Page 1 of 1 |
| Author: | rav [ Mon Sep 20, 2010 10:42 am ] |
| Post subject: | Handbrake microswitch |
Got a few scares over the weekend as the big red ! in the middle of the dash lit up. Seems that the micro switch under the handbrake is not fully depressing when i put the handbrake down. Is this alignment and setting up, or is it best to replace the switch altogether? |
|
| Author: | scam75 [ Mon Sep 20, 2010 11:20 am ] |
| Post subject: | Re: Handbrake microswitch |
Hi Rav Easy enough to investigate and adjust. It can only be on or off! I had to sort my own a while back, straight forward stuff. Stuart |
|
| Author: | DavidL [ Mon Sep 20, 2010 11:35 am ] |
| Post subject: | Re: Handbrake microswitch |
Rav, Probably the easiest switch to play with. There might be something stuck under where the plastic plunger goes so it doesn't drop properly or it might be electrical and the wires atre making a poor contact. Pull the carpet up under the hand brake and give it all a good clean. Mine's the opposite and the plunger stays down so the light only comes on if I poke it. Metsal needs a bit of bending that's all. |
|
| Author: | t3rra [ Mon Sep 20, 2010 12:04 pm ] |
| Post subject: | Re: Handbrake microswitch |
Cleaning the contacts with sand paper fixed mine, |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|