Porsche Enthusiasts Club Forum
https://forums.tipec.net/

S2 Rear Exhaust
https://forums.tipec.net/viewtopic.php?f=25&t=9115		 Page 1 of 1
Author:  AlporS2 [ Tue Jul 27, 2010 10:22 pm ]
Post subject:  S2 Rear Exhaust
Does anyone know if a Turbo rear exhaust section would be the same fit as that on a 944S2 ? Got an offer of a Dansk rear box to replace the one on my car which "rattles" alarmingly when cold, and now has a split in the silencer front end plate. The S2 system has a small silencer box just after the join to the centre section, whereas the Turbo one doesn't - will this make it more noiser ? I understand there is a sealer "ring" between the two sections, where do you think I could get one of those from ? Sorry if this has been asked before, I've looked through a few "old pages" but couldn't spot a previous item about this. Many thanks
Author:  frenchy [ Wed Jul 28, 2010 9:35 pm ]
Post subject:  Re: S2 Rear Exhaust
90% sure that the Turbo back section will not be a straight fit, but i may be wrong, try some specialist breakers and e bay and get one that is a straight swap.
HTH Jim.
Author:  AlporS2 [ Wed Jul 28, 2010 9:46 pm ]
Post subject:  Re: S2 Rear Exhaust
Many thanks Jim - you are right, the standard connection fitting is a 3 bolt plate, whereas the Dansk system has a more solid 4 bolt plate. After crawling right underneath the car tonight, I've found that the support bracket at this joint has fractured - which was causing the rattle :roll: The subsequent un-supported weight has then caused the silencer box to split too. I'll try my local garage to see if it can be welded, and get a new support bracket from my local spares supplier.
Many thanks for your response & advice. Alan
Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/