Porsche Enthusiasts Club Forum

I realise this is an open question and probably depends on whether the fixings can be removed but I need to either remove or drop one side of my bumper so I can get to some minor rust spot on the front on my O/S wing right on the join between the bumper and the wing, if I could drop this side by 1/2" -1" I could probably get to the rust any ideas?

There's 2 points of acesse, were you can un screaw the front wing from the top side of the bumper. 8 mm racket will be needed and some bendy wrists. If u havnt got the lower under tray then using extention bars u can reach theses bolts and turn from under the bumper., u can leave this on but will find it aword. The 1st bolts on each side can be undone slimply from the wheel arch, the rest will require

1st
there's a flap in the wheel arch liner. Push this in or pull out, your also want 2 turn wheels full lock.

2nd under the bonnet, near the right of the headlights Is a large 4/6" plug, remove, this is also used 2 get acsses 2 the headlight adjestment.

Thanks for the help if it stops raining at the weekend I might get it done.