Porsche Enthusiasts Club Forum
https://forums.tipec.net/

Rear wiper motor
https://forums.tipec.net/viewtopic.php?f=25&t=7765		 Page 1 of 1
Author:  footy10kid [ Mon Feb 08, 2010 8:01 pm ]
Post subject:  Rear wiper motor
hi does anyone have a decent rear wiper motor for sale my care is a 1988 944 lux bought 2 of ebay and one didnt work at all
other one started smoking
Author:  ben944 [ Mon Feb 08, 2010 8:36 pm ]
Post subject:  Re: Rear wiper motor
Hi,

When the rear wiper motor packs up, most owners replace it with a grommit, nut and bolt to bung up the hole in the rear screen for around 99p.

If you really want to replace it, you could try Porschapart for a good second hand rear wiper unit. I've been told that the rear wiper off a Renault Megane will fit and gives better wiper coverage at 20".

Unfortunately though, the wiper is set on the wrong side of the boot and IMO wipes the wrong side. Something that obviously benefits left hand drive cars.

Hope this helps.

Ben :bounce:
Author:  sulzeruk [ Tue Feb 09, 2010 8:21 am ]
Post subject:  Re: Rear wiper motor
What diameter of shaft does it have, I have a good thin one here for sale, may be have a later one as well, just needto test it,
Alasdair
Author:  footy10kid [ Tue Feb 09, 2010 11:47 am ]
Post subject:  Re: Rear wiper motor
not sure where to get a bung from they want £20 on ebay for one the shaftsize i have no idea off but aint they all the same on 944 its just the fitment is a little different
Author:  Scottish944 [ Tue Feb 09, 2010 1:57 pm ]
Post subject:  Re: Rear wiper motor
I have a 88 944 that I am removing a working rear wiper from. I just need to find a bung first
Author:  Scottish944 [ Tue Feb 09, 2010 4:39 pm ]
Post subject:  Re: Rear wiper motor
Image
Author:  J.J. [ Tue Feb 09, 2010 7:46 pm ]
Post subject:  Re: Rear wiper motor
I used an M6 cap screw & washers (Stainless) & a couple of black tap washers drilled 5.5mm. The washers are tapered & fit the hole on mine but there are two sizes. Mines the small one. Later hatches had a bigger hole. (Though tap washers come in larger sizes!) Don't pay £20 for a bung thats a rip off. It takes minutes to make your own. Grommets can be hard to find unless you wander around scrap yards a lot! :)
Author:  footy10kid [ Tue Feb 09, 2010 8:27 pm ]
Post subject:  Re: Rear wiper motor
Scottish944 wrote:
I have a 88 944 that I am removing a working rear wiper from. I just need to find a bung first




hi you can get a bung from ebay i seen them for £20 which i know is a lot how much do u want for the rear wiper motor
Author:  Scottish944 [ Tue Feb 09, 2010 8:28 pm ]
Post subject:  Re: Rear wiper motor
Made mine up from what I had lying about
Author:  Scottish944 [ Tue Feb 09, 2010 8:32 pm ]
Post subject:  Re: Rear wiper motor
footy10kid wrote:
Scottish944 wrote:
I have a 88 944 that I am removing a working rear wiper from. I just need to find a bung first




hi you can get a bung from ebay i seen them for £20 which i know is a lot how much do u want for the rear wiper motor


£13 + postage since your on tipec that will get me a new set of plugs :)
Author:  footy10kid [ Wed Feb 10, 2010 12:50 am ]
Post subject:  Re: Rear wiper motor
Scottish944 wrote:
footy10kid wrote:
Scottish944 wrote:
I have a 88 944 that I am removing a working rear wiper from. I just need to find a bung first




hi you can get a bung from ebay i seen them for £20 which i know is a lot how much do u want for the rear wiper motor


£13 + postage since your on tipec that will get me a new set of plugs :)



Thanks can i pay you via paypal if so what is your address you can email me at neilc@blueyonder.co.uk with the details
Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/