Porsche Enthusiasts Club Forum

Finally had the opportunity to offer up the wheels I bought a couple of months ago and the front seems to foul the strut.
I thought i had bought the right offset of 52.3 so they should bolt straight on, but now I'm not sure.
The part number is 928.361.016.00?
There now seems to be differing info on what I have googled.
Anyone help?
Peter
86 924S

Im no expert, but the 944 fitment tele dials have part number 951 *****.
928 teles are too wide.

don't 924s have 23 offset ? .... i may be wrong

924S has 15 x 6J 52.3.
The 928 wheels were 7J so should have fitted as I was told they were 52.3.
Now seems they might be 65 offset...
Peter
924S

Hi

All early 928 wheels have a 65 offset....

One point that may help....

On GENUINE Porsche wheels the offset is ALWAYS stamped into the wheel on either side of the valve with the width on the other side of the valve....

So on a 928 wheel you would see >> 7 VALVE 65 <<

All the best Brett

Four sets of long studs and spacers from the rear of a series one 944 will bring them out, if you really want to keep them. As others have already stated: 928 fitment wheels will have an offset of 65mm (about half an inch too inset for 924Ss and series two 944s).

Simon