| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Engine Cover/Camshaft Housing 944 s2 https://forums.tipec.net/viewtopic.php?f=25&t=2886 |
Page 1 of 1 |
| Author: | mikec [ Fri Apr 03, 2009 1:18 pm ] |
| Post subject: | Engine Cover/Camshaft Housing 944 s2 |
Does anyone know where to find instructions for checking/tightening the camshaft housing. Can't see it in the workshop manuals or seem to find it easily online. Cheers Mike |
|
| Author: | tr7v8 [ Fri Apr 03, 2009 1:42 pm ] |
| Post subject: | Re: Engine Cover/Camshaft Housing 944 s2 |
It isn't a service item to check but the manual gives 20nm or 15ft/lb as the torque for camhousing to head. |
|
| Author: | mikec [ Fri Apr 03, 2009 2:44 pm ] |
| Post subject: | Re: Engine Cover/Camshaft Housing 944 s2 |
Thanks. |
|
| Author: | mikec [ Fri Apr 03, 2009 6:19 pm ] |
| Post subject: | Re: Engine Cover/Camshaft Housing 944 s2 |
Can I just confirm that it is 20nm for the cover bolts. Just that I just checked the torque on the bolts on the cover on my car and they seem to have been torqued to about 10nm best I can tell. This would probably explain why I have oil seaping out. Cheers Mike |
|
| Author: | Richy_S [ Fri Apr 03, 2009 8:02 pm ] |
| Post subject: | Re: Engine Cover/Camshaft Housing 944 s2 |
You dont have a camshaft housing as such on an S2. You have a cylinder head and cover. The torque for the cover is 10Nm. Dont go any tighter as stripping those threads would be a pain. Rich |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|