| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Gear nob https://forums.tipec.net/viewtopic.php?f=25&t=2867 |
Page 1 of 1 |
| Author: | FROG 944 [ Mon Mar 30, 2009 10:25 pm ] |
| Post subject: | Gear nob |
Bought a new gear nob, after market job and went to fit it today and notice that the gaitor is part of the nob do they just untwist as a normal car does anyone know. Also got me some reclining race seats of fleabay so doing those too soon. |
|
| Author: | David924S [ Tue Mar 31, 2009 7:45 am ] |
| Post subject: | Re: Gear nob |
The gear knob does not just unscrew you have to lift the leather gaiter and remove a circlip at the lower end of the knob it will then lift off, I found the best way to get access was to remove the centre console or at least to unscrew it from the arm rest and stereo unit so it could be lifted to one side for access underneath (be careful not to damage the switches and connections. The gear knob is slotted to match the gear linkage which is flat not threaded. |
|
| Author: | ben944 [ Tue Mar 31, 2009 10:24 am ] |
| Post subject: | Re: Gear nob |
Hiya, You can do this without having to remove the centre console. The October 2006 copy of 911 and Porsche World has a 2 page spread on fitting a new gear knob and gaiter on a 944 on pages 112 and 113. If you can wait until Thursday when I'm back at work, I'll scan the relevant pages and try to post them on the forum. Failing that, I could always send you a photocopy or a pdf to your e-mail if it helps. It is relatively involved by the looks of it though. Regards, Ben 
|
|
| Author: | madrob6 [ Tue Mar 31, 2009 10:39 am ] |
| Post subject: | Re: Gear nob |
if it's a pre-oval dash you can just pull up on the plastic part that the gaiter is attached to, it's just clipped on. My gear nob isn't even clipped on so any castoffs will be appreciated 
|
|
| Author: | David924S [ Tue Mar 31, 2009 12:13 pm ] |
| Post subject: | Re: Gear nob |
When I said remove the centre console I only meant the section surrounding the gear lever, however what I failed to mention was when I did mine I replaced the linkage so taking out the console made it easier to replace the linkage ball/cup. If you want a good guide have a look on Clarkes garage section on thi website home page under resources, Garage Shop Manual, T for Transmission you will find a detailed description of how to remove the gearknob and any other parts you might want to replace. |
|
| Author: | FROG 944 [ Tue Mar 31, 2009 1:44 pm ] |
| Post subject: | Re: Gear nob |
Thanks ill have a look at Clarkes, if I get stuck ill get my email address to you Ben cheers for that. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|