Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
door removal https://forums.tipec.net/viewtopic.php?f=25&t=2516 |
Page 1 of 1 |
Author: | cococola [ Wed Jan 21, 2009 8:10 am ] |
Post subject: | door removal |
To remove my drivers door on my 944 do I simply unbolt the hinges from the pillar end,unbolt the door check strap and disconnect the wires to the door? If so 1.where does the wiring disconnect and2.is there anything to be wary of? I think this may be the best way to replace the hinge pins. cheers! |
Author: | Gazza944 [ Wed Jan 21, 2009 9:08 pm ] |
Post subject: | Re: door removal |
Ive taken doors off nearly every car Ive owned but if I remember correctly for the 944 the wiring all connects around the mirror. I do stand to be corrected though |
Author: | ExAudiSi [ Thu Jan 22, 2009 9:57 pm ] |
Post subject: | Re: door removal |
Gazza944 wrote: Ive taken doors off nearly every car Ive owned You been watching the Italian Job?? ![]() ![]() ![]() |
Author: | tr7v8 [ Thu Jan 22, 2009 10:38 pm ] |
Post subject: | Re: door removal |
ExAudiSi wrote: Gazza944 wrote: Ive taken the bloody doors off nearly every car Ive owned You been watching the Italian Job?? ![]() ![]() ![]() Edited by Michael Caine.... ![]() |
Author: | Gazza944 [ Fri Jan 23, 2009 10:24 am ] |
Post subject: | Re: door removal |
lol - i swear onn some of them blowing em off would have been easier |
Author: | cococola [ Sun Jan 25, 2009 1:51 pm ] |
Post subject: | Re: door removal |
I removed the door yesterday by unbolting the 4 hinge bolts on the door shut and slid the door off its holders.I hasd to disconnect the wiring 1st and then with brute force,knocked the hinge pins out. The wear was actually on the plastic inserts that the pins went into so using some hard plastic tubing I made sleeves for the pins.Hopefully these will be as tough as the original sleeves(I hope) |
Page 1 of 1 | All times are UTC |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |