Porsche Enthusiasts Club Forum
https://forums.tipec.net/

Rear 3/4 or wheelarch repair panel, steel not fibreglass
https://forums.tipec.net/viewtopic.php?f=25&t=24711		 Page 1 of 1
Author:  DavidL [ Wed Mar 10, 2021 9:46 am ]
Post subject:  Rear 3/4 or wheelarch repair panel, steel not fibreglass
I'm either going to need some proper fabrication for these or has anyone found any premade parts? Clubautosport do exactly what I need but its in fibreglass and the porsche pet showing the whole rear wing is now NLA.

Anyone found anything?

Thanks
Author:  Waylander [ Wed Mar 10, 2021 2:41 pm ]
Post subject:  Re: Rear 3/4 or wheelarch repair panel, steel not fibreglass
Get one cut off at a breakers, Douglas Valley?
Author:  51rider [ Wed Mar 10, 2021 6:55 pm ]
Post subject:  Re: Rear 3/4 or wheelarch repair panel, steel not fibreglass
I cannot vouch for them but I have found these chaps http://www.classiccarpartsandpanels.co.uk making parts for 924, 944 and 928 models. Might be worth an email or a call?
I hope the link works- I'm not too familiar with the forum settings :oops:
Author:  DavidL [ Wed Mar 10, 2021 10:28 pm ]
Post subject:  Re: Rear 3/4 or wheelarch repair panel, steel not fibreglass
Waylander wrote:
Get one cut off at a breakers, Douglas Valley?


That did occur to me but to be worthwhile it would need to be in perfect condition as there's no point in then having to repair the repair. As always mine was worse than I expected, on the surface it looked only when you start digging..
I'm not sure I'd trust having that sort of part sent remotely only to find it well and truly shagged.

Classiccarpartsandpanels do some repair panels but nothing suitable sadly.
Author:  Waylander [ Wed Mar 10, 2021 11:07 pm ]
Post subject:  Re: Rear 3/4 or wheelarch repair panel, steel not fibreglass
Get the arch and wheel well out of a 968, they don’t really rust in that area
Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/