| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Engine Cable Routing https://forums.tipec.net/viewtopic.php?f=25&t=24441 |
Page 1 of 1 |
| Author: | Picard1701 [ Sat Jun 13, 2020 2:19 pm ] |
| Post subject: | Engine Cable Routing |
So, the previous owner rebuilt my 2.7 1989 944 engine, and Porsche Tonbridge said the mechanicals are ok. However, the guys who rebuilt the engine did a lousy job of routing all the engine cables. Especially under the inlet manifold. Most of them and pipework are laying on the engine block! Which of course gets hot, so not good. Is there anybody in the SE that could reroute all the cables correctly and use the right cable ties etc. I have replaced all the mechanical stuff and she runs so well but I don't trust the cables and where they are located. Any help appreciated. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|