| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Cylinder head torque settings https://forums.tipec.net/viewtopic.php?f=25&t=24013 |
Page 1 of 1 |
| Author: | Redroadster [ Mon Jul 01, 2019 7:34 pm ] |
| Post subject: | Cylinder head torque settings |
Hi, I will be refitting the cylinder head on my 944 2.5 8v. Iv'e two different ways to torque it down. The first using 3 settings up to 66 ft lbs, the second tighten to 15 ft lbs then turn 90 degrees then 90 degrees again. Can anyone tell me the correct settings or procedure? |
|
| Author: | Tango130 [ Tue Jul 02, 2019 10:44 am ] |
| Post subject: | Re: Cylinder head torque settings |
As your car is an '83 Clark-Garage gives the torque spec as: Step 1: 20Nm Step 2: 50Nm Step 3: 90NM They also suggest waiting approx 15mins between each step. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|