| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Arnnworx rear bearing tool? https://forums.tipec.net/viewtopic.php?f=25&t=22760 |
Page 1 of 1 |
| Author: | zcacogp [ Thu Jun 29, 2017 10:38 pm ] |
| Post subject: | Arnnworx rear bearing tool? |
Chaps, Does anyone here have the Arnnworx rear bearing tool? If so, would you be willing to lend it to me (for the cost of postage and some beers, or a donation to a charity of your choice). Thanks, Oli. |
|
| Author: | 944-Scott [ Fri Jun 30, 2017 6:28 pm ] |
| Post subject: | Re: Arnnworx rear bearing tool? |
Is the bearing causing the knock? |
|
| Author: | Waylander [ Fri Jun 30, 2017 11:45 pm ] |
| Post subject: | Re: Arnnworx rear bearing tool? |
i borrowed the tool off someone on here, if you are going to diy it Oli, you might want to borrow my 500lb/f battery impact gun those rear hub nuts are tight, very tight |
|
| Author: | zcacogp [ Sun Jul 02, 2017 8:18 pm ] |
| Post subject: | Re: Arnnworx rear bearing tool? |
Martin, Thanks for the offer of the loan of an impact gun - I'll take you up on it! I'll eMail you. Anyone else know of the whereabouts of an Arnnworx hub bearing tool? Thanks, Oli. |
|
| Author: | kashurst [ Wed Jul 12, 2017 6:15 pm ] |
| Post subject: | Re: Arnnworx rear bearing tool? |
undoing the rear hub nuts can be very difficult. I took mine to a local truck/lorry repair place with serious airtools/sockets. They slackened them off for nothing (interested in the car) and did them up with a regular socket set for the short drive home. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|