| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| S1 Water temp and oil pressure gauges https://forums.tipec.net/viewtopic.php?f=25&t=22281 |
Page 1 of 1 |
| Author: | brulynn [ Sun Feb 12, 2017 3:14 pm ] |
| Post subject: | S1 Water temp and oil pressure gauges |
Both of the above gauges sit at max even after a long run, no overheat smells from the engine, no steam, no oil in the coolant and vice versa. I now have an infra red thermometer but have n't had a chance to use it yet. I have read Clarkes Garage on testing the gauges and I have the necessary variable resistor. My question is : how on earth do you disconnect the plug from the water temp gauge, I physically cannot reach the plug and I wondered how much dismantling is necessary to do so. Any advice gratefully received. Also do the gauges have a common earth point at the instrument console, if it was dodgy it might explain it. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|