| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| leather seats installed but https://forums.tipec.net/viewtopic.php?f=25&t=2216 |
Page 1 of 1 |
| Author: | trx [ Thu Nov 20, 2008 12:22 am ] |
| Post subject: | leather seats installed but |
Got my leather seats  Tuesday must admit they are in good nick very little wear but and theres always a but  they are both electric but with no plugs so how do i wind them down as my head is about 1" off the roof and my knees wrapped around the steering wheel.Dave |
|
| Author: | grbspeedster [ Thu Nov 20, 2008 8:46 am ] |
| Post subject: | Re: leather seats installed but |
i put temporary power on my sons when we fitted elec seats to his 924 turbo. Run lead from brown to earth and live lead (i put through inline fuse to be sure)to red and then you can move seat. I just took live straight from battery. Still need to wire up properley. Think i recall thread on Pelican Parts forum to do this |
|
| Author: | Brett928S2 [ Thu Nov 20, 2008 12:10 pm ] |
| Post subject: | Re: leather seats installed but |
Hi  I "think" you can also move the seats with an Allen key....but you may have to take the seats back out to do it  All the best Brett
|
|
| Author: | grbspeedster [ Thu Nov 20, 2008 2:51 pm ] |
| Post subject: | Re: leather seats installed but |
You can front to rear . If you take off front cover underseat you will see little crown wheel with allen key centre. This will move seats front to back, not sure on height adjust you may have to remove seat again to get at it |
|
| Author: | barks944 [ Thu Nov 20, 2008 7:53 pm ] |
| Post subject: | Re: leather seats installed but |
I ran a wire from the fusebox under the carpets over to the seat. Theres a few terminals on the underneath of the seat. Can quite remember how i wired it now, but i worked it out by trial and error then used some standard push fit electrical connectors in the end. Easy enough to do. |
|
| Author: | trx [ Thu Nov 20, 2008 11:48 pm ] |
| Post subject: | Re: leather seats installed but |
thanks folks will be having a look in the morning before i go to work. Dave |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|