| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| brake bleeding 1989 944 auto https://forums.tipec.net/viewtopic.php?f=25&t=22024 |
Page 1 of 1 |
| Author: | brunojaffa [ Sun Nov 06, 2016 5:24 pm ] |
| Post subject: | brake bleeding 1989 944 auto |
hi all. just about 90% finished my first 944 project replaced all brake and fuel pipes, calipers,discs tried bleeding brakes and no fluid coming through do i need ignition on or the engine running to do this thanx tony |
|
| Author: | col944 [ Sun Nov 06, 2016 5:40 pm ] |
| Post subject: | Re: brake bleeding 1989 944 auto |
No you don't need engine running. Some times when system is drained and then brakes pumped to push fluid through, the piston in the master cylinder goes further than it has for years, this can damage the seals and cause the system to stop working. You may need to rebuild or replace the master cylinder. Had this problem on my 924 after replacing all the discs, pipes and callipers. |
|
| Author: | stratfordshark [ Sun Nov 06, 2016 7:00 pm ] |
| Post subject: | Re: brake bleeding 1989 944 auto |
Absolutely no need for engine to be running since system is hydraulic! But a running engine does make stopping the car a little easier on the road... Did you bleed the calipers and flexible hoses before reconnecting them to hard lines (put end of flexible hose in cup of brake fluid, and apply vacuum at bleeder till fluid is flowing into catch container between vacuum pump and bleeder valve, then connect flexible hose to hard line)? Are the hard lines all new? There must be a huge volume of air in the system if you didn't, so what does the pedal feel like when you pump it (as previous poster says, try not to push pedal beyond normal range)? I use a power bleeder similar to this https://www.amazon.co.uk/dp/B000ROARTI/ ... T7FXNKWY47 which is a fantastic tool for efficient, one-man brake bleeding. With the amount of air you have in system it will be extra helpful. You don't even need to fill it but fill the reservoir, attach power bleeder and raise pressure to max 15psi. Then open a bleeder and wait for fluid to be pushed through. With the amount of air now in the system you may need to go round the car several times before all air is bled out, but this is no effort at all with a power bleeder. Get hold of the kind where you pump up pressure, not the kind pressurised by air in tyre as you have no control over the pressure, and the standard inflation pressure of a tyre is way higher than is safe to use on seals in master cylinder and servo. |
|
| Author: | AlpineTurbo [ Tue Nov 08, 2016 7:20 pm ] |
| Post subject: | Re: brake bleeding 1989 944 auto |
What Adrian said. Have you pump the pedal? IMO this will help with getting the air out. With an air bleeder like the Sealey, Laser version or even the Gunson's Eezibleed it does make the job easier. I have recently bled two cars like this. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|