| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Pop up light gaps https://forums.tipec.net/viewtopic.php?f=25&t=21636 |
Page 1 of 1 |
| Author: | HUBBA.HUBBA [ Mon Jul 04, 2016 7:26 pm ] |
| Post subject: | Pop up light gaps |
Being finicky, I have noticed one of my lights could do with sliding a couple of mm inwards, is there some adjustment somewhere? |
|
| Author: | Endoman [ Mon Jul 04, 2016 9:04 pm ] |
| Post subject: | Re: Pop up light gaps |
Check that the plastic pod is on the inside of the collar on the tilt shaft, you should be able to get a slight adjustment by releasing the screws and speed nuts. I am also very fussy about shut lines. Spent ages adjusting the bonnet . |
|
| Author: | Carrera RSR [ Mon Jul 04, 2016 10:24 pm ] |
| Post subject: | Re: Pop up light gaps |
There's shims for the inner wing pivot bracket to help move the pod inboard a mm or two |
|
| Author: | HUBBA.HUBBA [ Tue Jul 05, 2016 7:16 pm ] |
| Post subject: | Re: Pop up light gaps |
that's great, I'll have a look. cheers |
|
| Author: | t3rra [ Tue Jul 05, 2016 7:21 pm ] |
| Post subject: | Re: Pop up light gaps |
There's a few to many ways you can adjust. 3 nuts at each side off light, one been inside the wing. Then there's rod, and springs, Also the mounting point for the pop up rod. That's all providing your badge pannle and wings are in the right place. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|