Porsche Enthusiasts Club Forum

I remember reading a post about someone replacing this a while back but couldn't find it.

Does anyone know the type of hose, bore diameter, etc? How about the clips too?

Or just get it from Porsche?

Many thanks,

Dave.

its not expensive to get from Porsche I just replaced my entire system

As above its still available from Porsche I did mine last year, but specify the length you want as if you order it by part number alone you will get a 1 meter length.

Thanks Gents will go OPC

I notice the original washer hose clamps are a crimp type. Did you re-fit using the same type and what tool is needed to crimp them?

All the best,

Dave

Those are oetiker clamps

should be able to get the tool and clips from most motor factors