| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| does your sun-roof sit proud? https://forums.tipec.net/viewtopic.php?f=25&t=20747 |
Page 1 of 1 |
| Author: | Adrian [ Tue Dec 22, 2015 5:58 pm ] |
| Post subject: | does your sun-roof sit proud? |
....mine is flush at the front, but sits about 3mm proud along the rear edge.. is this common? |
|
| Author: | Waylander [ Tue Dec 22, 2015 6:51 pm ] |
| Post subject: | Re: does your sun-roof sit proud? |
mine is the other way round, I can get the rear flush but the front is a mystery |
|
| Author: | cococola [ Tue Dec 22, 2015 6:54 pm ] |
| Post subject: | Re: does your sun-roof sit proud? |
mine is flush all round |
|
| Author: | flt505 [ Tue Dec 22, 2015 7:18 pm ] |
| Post subject: | Re: does your sun-roof sit proud? |
Mine flush when closed. There is a plastic cog drive at the motor end which can break its teeth, allowing the panel not to close fully. There is also a pair of cog lifters on either side of the roof, which can be misaligned and cause a wonky closure. Best bet is to open the roof to the max, remove the roof panel, then 'close' the motor, retracting the lifter cogs. Refit the panel from the front, with the tags in place. The panel should then be flush all around. Then press 'open' and the lifter cogs should engage the roof panel. Press 'close' to then close the panel to its normal flush position. Dave CT |
|
| Author: | scm924s [ Wed Dec 23, 2015 7:53 pm ] |
| Post subject: | Re: does your sun-roof sit proud? |
It seems to be a problem with the replacement roof seals being a bit fatter than original. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|