Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
S2 engine wiring info https://forums.tipec.net/viewtopic.php?f=25&t=20601 |
Page 1 of 1 |
Author: | neal [ Sun Nov 15, 2015 5:23 pm ] |
Post subject: | S2 engine wiring info |
Hi could someone tell me please, the correct routing of the wiring for the oil pressure sender on the engine (where it runs around under inlet manifold across front of engine and down to sender) Thanks Neal |
Author: | neal [ Tue Nov 17, 2015 9:24 pm ] |
Post subject: | Re: S2 engine wiring info |
Hi, Or could someone be so kind as to photograph the the front of their engine please ? Regards Neal |
Author: | Rhett [ Wed Nov 18, 2015 12:45 am ] |
Post subject: | Re: S2 engine wiring info |
Hi, here is a photo of a 16V engine wiring, as you can see the cabling runs under the inlet manifold and across the front, then behind the plastic belt cover and down to the oil pressure switch and oil level switch (if fitted). It also goes to the hall sensor on the cam sprocket. I hope it helps! Attachment: Picture 014.jpg [ 151.74 KiB | Viewed 3850 times ] |
Author: | neal [ Thu Nov 19, 2015 10:51 pm ] |
Post subject: | Re: S2 engine wiring info |
Hi Rhett, thanks very much. So to be a pain but any chance of a photo further down on the left please ? Trying to see if wiring then runs down front of water pump before heading back to sender. Many Thanks again. Neal |
Author: | Waylander [ Fri Nov 20, 2015 9:14 am ] |
Post subject: | Re: S2 engine wiring info |
Yes it does |
Page 1 of 1 | All times are UTC |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |