| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Cv joint bolts https://forums.tipec.net/viewtopic.php?f=25&t=20175 |
Page 1 of 1 |
| Author: | marks2ply [ Wed Jul 22, 2015 8:35 pm ] |
| Post subject: | Cv joint bolts |
Hi all When renewing grease and boots is it necessary to replace all bolts and plates and if so where can I purchase them at a reasonable price. Mark |
|
| Author: | tr7v8 [ Wed Jul 22, 2015 8:54 pm ] |
| Post subject: | Re: Cv joint bolts |
You should they are stretch bolts. More than one person has had them come undone & cause damage. The plates are OK to reuse. A lot of the after mrket ones are hex headed cap screws rather than the 12 points. I bought mine from an OPC with TIPEC discount. |
|
| Author: | marks2ply [ Thu Jul 23, 2015 8:46 am ] |
| Post subject: | Re: Cv joint bolts |
Thanks Jim Any Idea on the cost of the bolts and plates? Mark |
|
| Author: | tr7v8 [ Thu Jul 23, 2015 10:01 am ] |
| Post subject: | Re: Cv joint bolts |
marks2ply wrote: Thanks Jim Any Idea on the cost of the bolts and plates? Mark Plates you can clean & reuse, the bolts were around £2ish each. Design 911 quote £1.75 as an example. |
|
| Author: | Carrera RSR [ Thu Jul 23, 2015 6:21 pm ] |
| Post subject: | Re: Cv joint bolts |
tr7v8 wrote: marks2ply wrote: Thanks Jim Any Idea on the cost of the bolts and plates? Mark Plates you can clean & reuse, the bolts were around £2ish each. Design 911 quote £1.75 as an example. Therefore about a £1 each from OPC. Just did mine and don't remember spending over £25 for a set |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|