Porsche Enthusiasts Club Forum

Hi
Any ideas my clutch is not releasing on my 944 turbo been in my garage and not moved for about four months.
Replaced the pipe from the filler to master cylinder and bleed it all through.
I am getting the correct dimension from the slave cylinder and that part seems fine,
Can the clutch plate stick even if the hydraulics are working.

Thanks
Brian

Yes it can stick, let the engine warm fully and the heat might help it break free, had this issue with a few cars over the years.

Also try pulling the king lead from the coil, put the car in gear brakes on clutch to the floor then turn the key,

Option two, get a few mates round to rock the car in gear with the clutch pressed fully down see if that will break it free

I will try running the engine until it is warm did pop the dme and tried starting in gear with clutch depressed
Did not release the clutch will give it another go

Thanks