Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
photos of cable routing within the car with carpet removed https://forums.tipec.net/viewtopic.php?f=25&t=20111 |
Page 1 of 1 |
Author: | avants2turbo [ Sun Jul 05, 2015 7:28 pm ] |
Post subject: | photos of cable routing within the car with carpet removed |
trying to refit the carpet in a 968, the loom and carpet are from a 944 turbo and im having issues with the routing of the cables under the carpet, along the sill area each side and under the passenger side carpet |
Author: | kongsodoken [ Sun Jul 05, 2015 8:07 pm ] |
Post subject: | Re: photos of cable routing within the car with carpet remov |
Mine been in bits longer than I can remember but I think the cable sits above the carpet and is covered by the sill finisher but I'll stand corrected if anyone knows better ![]() |
Author: | Waylander [ Sun Jul 05, 2015 9:14 pm ] |
Post subject: | Re: photos of cable routing within the car with carpet remov |
Correct, I'm sure your right Ken |
Author: | JasonGibson [ Sun Jul 05, 2015 10:57 pm ] |
Post subject: | Re: photos of cable routing within the car with carpet remov |
Its certainty like that on my 24 had the carpets up many times on both to install new speaker cabling. a decent adhesive is required to keep it in place |
Author: | TonyKart [ Wed Jul 08, 2015 4:32 pm ] |
Post subject: | Re: photos of cable routing within the car with carpet remov |
Passenger side, cabling runs along floor, pushed up against sill - cabling pulled out to ease access in photo ![]() Drivers side again along floor, pushed against sill, cabling lifted to ease access ![]() |
Author: | kongsodoken [ Wed Jul 08, 2015 7:42 pm ] |
Post subject: | Re: photos of cable routing within the car with carpet remov |
I'm sure that's not standard, must get in the way of the handbrake ![]() |
Author: | TonyKart [ Thu Jul 09, 2015 8:54 am ] |
Post subject: | Re: photos of cable routing within the car with carpet remov |
kongsodoken wrote: I'm sure that's not standard, must get in the way of the handbrake ![]() Cabling has been lifted to allow access to floor, as I was removing sound deadening |
Page 1 of 1 | All times are UTC |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |