| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| s2 wheel stud size? https://forums.tipec.net/viewtopic.php?f=25&t=19355 |
Page 1 of 1 |
| Author: | HUBBA.HUBBA [ Tue Feb 17, 2015 8:09 pm ] |
| Post subject: | s2 wheel stud size? |
I've had to get a seized locking nut off and there is now a bit damage to the thread ( not much) so I need to get a die to clean it up. The replacement lock nuts say M14 x1.5 but I'm mot sure if thats a fine thread or not. Also I cant believe how hard the normal nuts were done on, are they made of a special alloy, they are super light (compared to anything I have had before)? |
|
| Author: | scam75 [ Tue Feb 17, 2015 8:24 pm ] |
| Post subject: | Re: s2 wheel stud size? |
They are aluminium and should be tightened to 130nm. The 944 is sensitive to incorrect torque on the wheel nuts and as such improperly torqued wheel nuts can cause wobbles and shudders. Stuart |
|
| Author: | HUBBA.HUBBA [ Tue Feb 17, 2015 10:14 pm ] |
| Post subject: | Re: s2 wheel stud size? |
Thanks for that. Don't suppose you know about the thread type |
|
| Author: | Waylander [ Wed Feb 18, 2015 12:36 am ] |
| Post subject: | Re: s2 wheel stud size? |
Buy a new stud, that's got to be safer and stronger |
|
| Author: | sgl1966 [ Wed Feb 18, 2015 8:42 am ] |
| Post subject: | Re: s2 wheel stud size? |
Hi, I have both front and rear studs here after replacing mine for longer (wheel spacers). PM your address and what length you want (front and rear are different length) and I will send one out to you. Its got to be safer. |
|
| Author: | zedhex [ Wed Feb 18, 2015 10:45 am ] |
| Post subject: | Re: s2 wheel stud size? |
I you have two front studs available, I need them - can you PM me? Thanks |
|
| Author: | sgl1966 [ Wed Feb 18, 2015 3:59 pm ] |
| Post subject: | Re: s2 wheel stud size? |
PM sent zedhex. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|