Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
944 starter ring gear and fuel lines wanted https://forums.tipec.net/viewtopic.php?f=25&t=18987 |
Page 1 of 1 |
Author: | Steve L [ Sat Dec 06, 2014 7:48 pm ] |
Post subject: | 944 starter ring gear and fuel lines wanted |
I am having the clutch replaced on my 87 944 lux and it turns out that the starter ring gear is somewhat worn. I am looking for a new, or second hand one in good condition - can anyone help. Porsche are non comittal about whether they have / can supply one. I have found a couple on ebay in the states which seem OK but my car is on the ramp in bits in my local garage and I need one as soon as possible. Also, while the gearbox is off, it would make sense to replace the fuel line as it is somewhat corroded above the back axle. Any ideas where I can get a replacement kit at a reasonable cost. How many pieces does it come in and how much should I expect to pay. All advice appreciated. Thanks. Steve |
Author: | Waylander [ Sun Dec 07, 2014 3:32 pm ] |
Post subject: | Re: 944 starter ring gear and fuel lines wanted |
Lines are about £100 from OPC |
Author: | tr7v8 [ Sun Dec 07, 2014 6:06 pm ] |
Post subject: | Re: 944 starter ring gear and fuel lines wanted |
Best way with the lines is to use Pirtek or similar flexi & jus replace what is needed with flared joints. Or use standard olives & plumbing bits. Mine had been done with high pressure hose & jubilee clips. Never gave any trouble. |
Author: | marks2ply [ Mon Dec 08, 2014 9:20 pm ] |
Post subject: | Re: 944 starter ring gear and fuel lines wanted |
Hi with the fuel lines i removed the two offending lines from midway under the vehicle, cutting the sound pipework with a pipe cutter for a clean finish. make sure you stagger the cuts. Disconnecting at the flexi pipes at the other end the patterns were then taken to pirtek and they produced me two lines with all the fittings required, I asked them to be made 30cm longer than the pattern supplied to allow re-routing slightly. The hoses are teflon overbraided hoses. The guys supplied me with a compression fitting in stainless for connection under the car. I bought 4 new clamps from the opc to clamp all back into place. cost about 180 GBP. Saves on dropping the rear beam which you will need to do to fit oe lines. regards Mark |
Author: | Steve L [ Mon Dec 08, 2014 10:24 pm ] |
Post subject: | Re: 944 starter ring gear and fuel lines wanted |
Thanks guys for the advice, much appreciated. Steve |
Author: | Waylander [ Tue Dec 09, 2014 12:31 am ] |
Post subject: | Re: 944 starter ring gear and fuel lines wanted |
checked pet the main and return line are about £65.00 each from Porsche so not anymore expensive than the plastic fix |
Page 1 of 1 | All times are UTC |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |