| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| Trim panel under bridge spoiler https://forums.tipec.net/viewtopic.php?f=25&t=18227 |
Page 1 of 1 |
| Author: | marks2ply [ Sun Jul 27, 2014 9:43 am ] |
| Post subject: | Trim panel under bridge spoiler |
Hi all the trim panel under the bridge spoiler has come adrift, it looks like it is just bonded on to some support plates. Guys what should i use to rebond the panel on? Mark |
|
| Author: | DaveM [ Sun Jul 27, 2014 2:37 pm ] |
| Post subject: | Re: Trim panel under bridge spoiler |
None of the bridge spoiler trims are bonded on. There are 3 or 4 screws underneath that hold it in place. |
|
| Author: | tp_reading [ Sun Jul 27, 2014 4:23 pm ] |
| Post subject: | Re: Trim panel under bridge spoiler |
I used Tiger Seal on mine, still stuck after 3 years. Important to make sure the surfaces to be bonded together are absolutely clean ! |
|
| Author: | kongsodoken [ Sun Jul 27, 2014 4:51 pm ] |
| Post subject: | Re: Trim panel under bridge spoiler |
There are metal brackets that are bonded onto the fibre trim piece The brackets can come adrift, but can easily be glued back again, should be obvious where they were bonded These brackets are then pushed over the tabs on the tailgate frame and are bolted from underneath |
|
| Author: | marks2ply [ Sun Jul 27, 2014 4:55 pm ] |
| Post subject: | Re: Trim panel under bridge spoiler |
It is definitely bonded, so if Tiger Seal is still going strong after 3 years I am happy to use this. Thanks for the advice guys. Mark |
|
| Author: | 944-Scott [ Mon Jul 28, 2014 6:08 pm ] |
| Post subject: | Re: Trim panel under bridge spoiler |
Tiger seal should do it, I fibre glassed mine back into place. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|