Porsche Enthusiasts Club Forum
https://forums.tipec.net/

I Need To Remove The Turbo
https://forums.tipec.net/viewtopic.php?f=25&t=15641		 Page 1 of 1
Author:  944-Scott [ Sat Jun 22, 2013 8:40 pm ]
Post subject:  I Need To Remove The Turbo
But hopefully not completely. Im looking for tips so I can free it off to give me some movement. A broken stud on on the outlet pipe has led to it being replaced and I have managed to get that off without removing the Turbo but as the new pipe is larger I need at least some movement in the turbo to fit i, any tips?

Shiny goodness


Image
Author:  andycowman [ Sat Jun 22, 2013 9:23 pm ]
Post subject:  Re: I Need To Remove The Turbo
There are two 'hex' head bolts that hold he turbo itself down, when loosening these i found it quite important to follow step 20 from Clarkes Garage! They came out cleanly and apart from a sheared stud for the down pipe (re drilled and tapped in a new one) it was straight forward

http://www.clarks-garage.com/pdf-manual/eng-16.pdf
Author:  944-Scott [ Sat Jun 22, 2013 9:37 pm ]
Post subject:  Re: I Need To Remove The Turbo
Cheers

Looking at the parts diagram I see there is a seal in underneath, whats it sealing against, oil?
Author:  andycowman [ Sun Jun 23, 2013 11:51 am ]
Post subject:  Re: I Need To Remove The Turbo
Yes thats oil, there is one on top as well. My lower was leaking which was part of the need to remove the turbo. They were a few pounds if that from the OPC as memory serves. Might be worth ordering up a set whilst you are in there?
Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/