Porsche Enthusiasts Club Forum
https://forums.tipec.net/

Retracting the backshelf cover
https://forums.tipec.net/viewtopic.php?f=25&t=14903		 Page 1 of 1
Author:  Wicksay [ Fri Mar 15, 2013 5:04 pm ]
Post subject:  Retracting the backshelf cover
My covers stuck and won;t retract. Any suggestions how to free it up? Do I need to remove it? Can I sort out in situ?

Thanks
Wicksay :albino:
Author:  t3rra [ Sat Mar 16, 2013 10:20 pm ]
Post subject:  Re: Retracting the backshelf cover
Are the end caps still there? These are like roller blinds and this is what center pole rolls on
Author:  AlpineTurbo [ Sat Mar 16, 2013 10:42 pm ]
Post subject:  Re: Retracting the backshelf cover
A lack of use does not tend to help the covers out. When you disengage the load cover from its hooks on the rear panel, try to pull it out a little further, or feed it into the roller. One of these operations will tend to help the cover along.

It certainly did in both of my 944s.
Author:  Phil3822 [ Sun Mar 17, 2013 11:03 am ]
Post subject:  Re: Retracting the backshelf cover
I'm still trying to find how to free the hood from the fixed into boot position. Simple as this probably is, I am somewhat simpler in mind.
Author:  Wicksay [ Mon Mar 18, 2013 8:51 am ]
Post subject:  Re: Retracting the backshelf cover
I found another solution>¬ :bounce:

Leave it. I came back to it a couple of days later and it a retracted itself enough to be used again.

Clearly it needs some attention so I will spend some time tackling some basic servicing with it.

Thanks for the tips guys.

Wicksay
Author:  broady_6 [ Thu Mar 21, 2013 9:18 pm ]
Post subject:  Re: Retracting the backshelf cover
i tried pulling mine out further and now ive got a cover thats even longer than before! I have to feed it in inch by inch haha
Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/