| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| wanted https://forums.tipec.net/viewtopic.php?f=25&t=12566 |
Page 1 of 1 |
| Author: | rapidstu [ Mon Mar 19, 2012 5:52 pm ] |
| Post subject: | wanted |
i am after the 2 old connectors that come with the brake pad wear sensors, i want to cut of the worn sensors and join tghe 2 wires together. apparently this will turn of my warning light. thanks |
|
| Author: | scam75 [ Tue Mar 20, 2012 1:21 pm ] |
| Post subject: | Re: wanted |
It will indeed. What is wrong with your own broken sensors? Are they MIA? Stuart |
|
| Author: | rapidstu [ Tue Mar 20, 2012 6:03 pm ] |
| Post subject: | Re: wanted |
New ebc pads without the sensors, as the wheels come off very regularly i check then. |
|
| Author: | scam75 [ Tue Mar 20, 2012 7:05 pm ] |
| Post subject: | Re: wanted |
Hi Stu The sensors don't come with the pads and are less than a tenner new. Surely that is your best option? Or do your EBC's not have the groove on them to accept the sensor? If so you can just bridge the 2 connectors where the sensor should plug in, will do the same job and probably less messy. Stuart |
|
| Author: | rapidstu [ Tue Mar 20, 2012 8:34 pm ] |
| Post subject: | Re: wanted |
Hi Stuart, yes thats what i want to do, but by using the old connector ( on the wear indicators) and joining the wires i keep the water seals and avoid internal corrosion, if at a later date i wish to use the sensors i can just un-plug my shorting block and fit the new ones. As i have a set of track wheels and a road set i will ( should ) know the condition of the pads stu |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|