Bosch DME (as nature intended)
| Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
| What ECU do people run? https://forums.tipec.net/viewtopic.php?f=25&t=11464 |
Page 1 of 1 |
| Author: | andycowman [ Mon Aug 08, 2011 9:17 pm ] |
| Post subject: | What ECU do people run? |
Hello Just curious about what other set ups people are running in their cars. Mine is 87 Turbo running a full Emerald Install. Anyone else running that? |
|
| Author: | Mike968 [ Tue Aug 09, 2011 7:07 am ] |
| Post subject: | Re: What ECU do people run? |
Bosch DME (as nature intended)
|
|
| Author: | andycowman [ Tue Aug 09, 2011 4:15 pm ] |
| Post subject: | Re: What ECU do people run? |
Mike968 wrote: (as nature intended) Sadly nature intended mine to fry itself!!! |
|
| Author: | andycowman [ Thu Aug 11, 2011 5:52 pm ] |
| Post subject: | Re: What ECU do people run? |
So does everyone else run standard?! Am I the only idiot with an after market setup!? |
|
| Author: | jameso [ Thu Aug 11, 2011 8:51 pm ] |
| Post subject: | Re: What ECU do people run? |
I run Microsquirt, fuel only on this car but the last one was fuel and spark. Out of interest how does the emerald ecu deal with the crank timing? |
|
| Author: | J.J. [ Thu Aug 11, 2011 8:53 pm ] |
| Post subject: | Re: What ECU do people run? |
Had a live remap from Wayne Scholfield on mine. The stock chip is live mappable. So old no protection. Well worth it even on a N/A. Total cost including injector clean was only £300 & the best money I ever spent on her. Only trouble was needed a turbo clutch & new drive shafts afterwards to cope with the power. 
|
|
| Author: | andycowman [ Fri Aug 12, 2011 6:45 am ] |
| Post subject: | Re: What ECU do people run? |
jameso wrote: I run Microsquirt, fuel only on this car but the last one was fuel and spark. Out of interest how does the emerald ecu deal with the crank timing? Very easily - I just had a bracket made up that is attached to the front of the block that holds a bog standard sensor - then I have a trigger wheel fitted to the main crank pulley. A very simple solution for crank timing! It was also a prime time to switch to a MAP sensor. On the cards next year are moving from dizzy to coil packs and switching out the injectors to standard ones! |
|
| Author: | Brett928S2 [ Fri Aug 12, 2011 11:46 pm ] |
| Post subject: | Re: What ECU do people run? |
andycowman wrote: jameso wrote: I run Microsquirt, fuel only on this car but the last one was fuel and spark. Out of interest how does the emerald ecu deal with the crank timing? Very easily - I just had a bracket made up that is attached to the front of the block that holds a bog standard sensor - then I have a trigger wheel fitted to the main crank pulley. A very simple solution for crank timing! It was also a prime time to switch to a MAP sensor. On the cards next year are moving from dizzy to coil packs and switching out the injectors to standard ones! Hi  I am not sure I would switch to coil packs, as a lot of them have a high failure rate...try and get some recommendations for reliable ones at the least... All the best Brett
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|