Porsche Enthusiasts Club Forum
https://forums.tipec.net/

944 Bellhousing Bolts
https://forums.tipec.net/viewtopic.php?f=25&t=10713		 Page 1 of 1
Author:  Rapid_Gav [ Mon Mar 28, 2011 10:41 am ]
Post subject:  944 Bellhousing Bolts
Hi everyone :D

I've a 1985 2.5 8v 944 which came with a spare engine. The spare engine as been sitting on my lock-up floor for quite some time and is getting in my way so I'm looking to relocate it onto an engine stand. I've aquired a stand from my work (found it dismantled behind a load of racking - nobody knew why it was there or what it was so I luckily got it FOC) and have it assembled and ready to be put to use. Here lies my problem.

There were no bolts provided with the spare enigne and after checking the manaul came to the conclusion that the bolts were all M12; (items 26 and 27 below)

Image

Image

But when I offered up a M12 bolt to the tapped holes of the block I had no luck at all in getting them in. Can anyone confirm that the pitch of the thread is of these bolts? I'm guessing they could well be fine thread. I was thinking that perhaps the threads had just galled up and would need tapped but I'm not wanting to try that until I've confirmation of the pitch as I've only got a M12 course tap at the moment.

Cheers,

Gavin.
Author:  madrob6 [ Mon Mar 28, 2011 10:45 am ]
Post subject:  Re: 944 Bellhousing Bolts
Yup they're fine thread. I had to buy 2 longer bolts to get mine on the stand as the top two are quite short due to the shape of the bellhousing.

I also had to pad the top bolts out with some extra washers.
Author:  Rapid_Gav [ Mon Mar 28, 2011 10:57 am ]
Post subject:  Re: 944 Bellhousing Bolts
madrob6 wrote:
Yup they're fine thread. I had to buy 2 longer bolts to get mine on the stand as the top two are quite short due to the shape of the bellhousing.

I also had to pad the top bolts out with some extra washers.


Cheers for that, top marks for such a prompt response too! :P
Author:  sulzeruk [ Mon Mar 28, 2011 12:43 pm ]
Post subject:  Re: 944 Bellhousing Bolts
Mr Rapid, I may have some longer bolts you can have for the price of the postage if you want,
Alasdair
Author:  Rapid_Gav [ Mon Mar 28, 2011 2:04 pm ]
Post subject:  Re: 944 Bellhousing Bolts
sulzeruk wrote:
Mr Rapid, I may have some longer bolts you can have for the price of the postage if you want,
Alasdair


PM sent
Author:  Rapid_Gav [ Mon Apr 11, 2011 8:36 am ]
Post subject:  Re: 944 Bellhousing Bolts
Bolts received thank you Alasdair!

I'll post up some pics once I get round to my lock up.
Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/