As the title says after a bit of advise.
When i bought the '44 it had an aftermarket rear fog switch, just fitted a new trim section with a proper one and luckily the PO bodge was just to wrap wires around the old pins, but I can't find anywhere that shows the order that the pins need to be connected to the correct fog light switch, can anyone help out?
Also just been really lucky and picked up a replacement radiator locally ( mine has a slight leak ) but its from an S2 so has the 3 pin sensor as it would normally trigger the 2 fans, as I'll be just retro fitting it with the single 2.5 fan, which pins do I use?
Thanks in advance
