PaulPSB wrote:
Thought it was time for an update.
The donor block sourced via the 924 club proved more trouble than it was worth so decided to rebuild the original.
There has been a long delay as main bearings were simply not available. Big ends, piston rings, gaskets all easily obtained but haven't been able to give the engineering company the go ahead until main bearings finally sourced via Mittelmotor.
They are .25mm oversize (the only ones available) so the main journals will be machined to suit, big ends will remain standard. The cylinders are to be bored out to accept liners so the original pistons can be re-fitted. Hopefully this will all be completed over the next few weeks.
The suspension, fuel system, braking system have all be completely renewed and the car has been registered as a historic vehicle so now MOT exempt. With the engine sorted I'm hoping she will be back on the road before the end of the year
There is a source in 924OC for mains v going to Mittelmotor...new pistons (to any spec), rings etc. are also available