Porsche Enthusiasts Club Forum

It is currently Fri Jul 11, 2025 5:01 pm
Classic Line Insurance


All times are UTC




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: 1987 944 Turbo Sensors on Clutch Bellhousing
PostPosted: Wed Sep 16, 2015 8:07 pm 
Offline

Joined: Wed May 13, 2015 7:58 pm
Posts: 7
TIPEC membership: 0
Hi,
I have just fitted my new 944 Turbo engine (see my other posts). I am trying to sort out the birds nest of fuel,air,water pipes and electric string! At the rear of the intake manifold there is a bracket with 2 black electrical sockets that go down to the 2 sensors mounted on the clutch bellhousing. The 2 electrical plugs that go on the sockets are identical and do not have any keyway to prevent them being cross connected. Anybody know how I figure out which goes to which?

GT


Top
 Profile  
Reply with quote  
 Post subject: Re: 1987 944 Turbo Sensors on Clutch Bellhousing
PostPosted: Thu Sep 17, 2015 12:59 pm 
Offline
User avatar

Joined: Sat Aug 01, 2015 10:48 am
Posts: 251
TIPEC membership: 0
Hi GT

This is one of those...'lack of forethought' designs, imho they should have used two different multi-plugs for these two sensors even if they are both the same or a means of identifying the correct cable. Since both go to the ECU the only way of identifying which is which is by using a multi-tester across the pins in the ECU( wiring diagram needed), however since you won't do any harm getting this wrong, it will either start or not start you could just take pot luck and see if the car runs. Mind you when fitting a new engine as you are this isn't very helpful if there's an unknown fault. IIRC the sensor nearest the block is the speed sensor. What is important though is the gap between sensor and contact screws on the flywheel, this should be around 0.8mm. It's worth spending a little time here to get this right, an old sensor can help by gluing a 0.8mm spacer to it and setting the adjusting bracket for this depth and then replace with new sensor. You would need access to a lathe to turn up an accurate spacer and also a very strong glue designed for metal as the last thing you need is this dropping inside the bellhousing, I use something like loctite 648 for such things.

regards

Pete

edit:...I've just been reminded by my son that the original harness had ID tags on the loom...it's been a very long time since my car had Porsche wiring....:)

_________________
86 951 heavily modified...400+bhp


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC


Who is online

Users browsing this forum: Bing [Bot] and 23 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group