Porsche Enthusiasts Club Forum https://forums.tipec.net/ |
|
987 Coffin Arm Ball joint https://forums.tipec.net/viewtopic.php?f=10&t=24809 |
Page 1 of 1 |
Author: | 563 [ Wed Jul 21, 2021 3:16 pm ] |
Post subject: | 987 Coffin Arm Ball joint |
I am replacing the coffin arms on the rear of our 2006 Cayman S and am unable to split the ball joint. I have tried the 2 hammer technique and a tuning fork wedge. I have a joint splitter with the pivot in the middle and a large bolt at the end but this does not go sufficiently into the joint to put pressure squarely on the ball joint nut. I have been spraying with Wurthe Rust Off and have tried a little heat from a small plumbing torch but I am reluctant to overheat the alloy upright. Would be grateful for any useful suggestions. |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |