| Porsche Enthusiasts Club Forum http://forums.tipec.net/ |
|
| dreaded downshift shudder 3rd to 2nd http://forums.tipec.net/viewtopic.php?f=25&t=24321 |
Page 1 of 1 |
| Author: | jenko [ Wed Mar 11, 2020 5:03 pm ] |
| Post subject: | dreaded downshift shudder 3rd to 2nd |
So, Not many miles on my replacement clutch and getting a severe shudder through the back of the car, gearstick and transmission. Had a new sachs spring centre clutch installed and after putting not many miles on it is now shuddering really badly only on changing down 3rd to 2nd. Even rev matching is not helping and also doing it around town speeds. Before I start chucking ££'s at it, anyone else had this and fixed it? So far the culprits include: worn splines on torque tube or badly installed clutch? Any help would be appreciated as this is driving me nuts! |
|
| Author: | Kas750 [ Thu Mar 12, 2020 9:05 am ] |
| Post subject: | Re: dreaded downshift shudder 3rd to 2nd |
worn/loose mounts would be a good, cheap place to start. |
|
| Author: | jenko [ Thu Mar 12, 2020 9:55 am ] |
| Post subject: | Re: dreaded downshift shudder 3rd to 2nd |
Kas750 wrote: worn/loose mounts would be a good, cheap place to start. the gearbox mounts are new.... |
|
| Author: | Kas750 [ Thu Mar 12, 2020 7:22 pm ] |
| Post subject: | Re: dreaded downshift shudder 3rd to 2nd |
Can still be loose though..Genuine parts? |
|
| Author: | jenko [ Thu Mar 12, 2020 8:37 pm ] |
| Post subject: | Re: dreaded downshift shudder 3rd to 2nd |
Kas750 wrote: Can still be loose though..Genuine parts? they were reassuringly expensive yes... My mechanic said the engine mounts are okay but might replace anyway... Worried its a the clutch... |
|
| Author: | Kas750 [ Thu Mar 12, 2020 8:45 pm ] |
| Post subject: | Re: dreaded downshift shudder 3rd to 2nd |
Due diligence to do the checks outside.Good luck |
|
| Author: | jenko [ Thu Mar 26, 2020 4:44 pm ] |
| Post subject: | Re: dreaded downshift shudder 3rd to 2nd |
new engine mounts = tick Problem solved = no  What's next ? take the clutch out and take a look? My mechanic guy reckons it could be that the clutch was not balanced correctly when installed? If so its a big expenses to take it out and re-do ? Really annoying as the clutch is fairly new and was installed by a "specialist"... |
|
| Author: | 944-Scott [ Thu Apr 02, 2020 10:47 pm ] |
| Post subject: | Re: dreaded downshift shudder 3rd to 2nd |
Bearings moved in torque tube? |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|