Ran into a bit of an issue with the coolant flange, I either modify the plastic housing which I don't really want to have to do, make a new coolant flange with takeoffs of modify the bulkhead a touch to allow the standard one to fit.
Got the heater out to have a look at modifying the bulkhead but the bar that runs from the brake pedal to the cylinder sits pretty close to the bulkhead, so not much room for cutting and welding. I could buy a floor mounted pedal box and do away with it all including the Servo, which would mean not having to cut down the inlet manifold, use a hydraulic clutch aswell, but its not a cheap option. I could try cutting an welding the brake to cylinder bar but its not ideal, has anyone removed one before?
Made a dodgy cardboard template for my tunnel and for my new centre console so I can make some steel ones.
Anyway so photos....
The Brake Bar
Even with the coil mount removed the sensors and back of the housing just catch the bulkhead
Making sure the templates fit with the dash
Still loads to do, hopefully get my tunnel welded and mounts made this weekend