Porsche Enthusiasts Club Forum http://forums.tipec.net/ |
|
Alloys? http://forums.tipec.net/viewtopic.php?f=14&t=24608 |
Page 1 of 1 |
Author: | cpr0305 [ Mon Nov 16, 2020 8:35 pm ] | ||
Post subject: | Alloys? | ||
Hi, Can anybody confirm what model/make of alloys these are, I have a set of 4 at work which have been stored there for quite a while, will there be a serial number on them anywhere? These are 16”. Regards Chris.
|
Author: | Baztop [ Tue Nov 17, 2020 6:30 pm ] |
Post subject: | Re: Alloys? |
Hiya, That's a Teledial wheel from the late 1980's and early 1990's I think. My guess is as a 16 inch wheel it's probably off a 928, as I think the 924/944 were 15 inch then. They are often on Ebay for silly amounts of money, so might be worth getting them cleaned up. |
Author: | cpr0305 [ Tue Nov 17, 2020 7:01 pm ] |
Post subject: | Re: Alloys? |
Hi mate, Thankyou so much for the information, very helpful. I will have a look around, never knew they would possibly be worth anything, Thanks again. Regards Chris. |
Author: | autonoob [ Thu Jan 07, 2021 3:14 am ] |
Post subject: | Re: Alloys? |
What are your plans for this old wheel? Are you planning to restore it or just replace it? |
Author: | tr7v8 [ Thu Jan 07, 2021 9:54 am ] |
Post subject: | Re: Alloys? |
If you clean off the back there will be some dimension on it plus an ET or offset figure. There were 944s with 16" teledials. The ET figure should date it. |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |